Error UFS 0002.00 0xEC scsi read 10 f64

Administrators

Administrators

Administrators
Staff member
Administrators
Joined
Nov 13, 2016
Messages
2,958
Reaction score
1,510
Points
114
Age
38
Location
dhaka
Error UFS_0002.00 0xEC scsi_read_10 STALL_CONDITION at LBA: 0x001EB000

Task Done!
Duration: 00:00:09

Read Task LUN0
Logical Block Address: 0x0000000000000000
Number of Bytes: 10,674,507,776 Bytes (9.94 GB)
Starting...

Error UFS_0002.00 0xEC scsi_read_10 STALL_CONDITION at LBA: 0x001EB000
(Check detailed report on JEDEC® log tab)
Warning GET_UFS_HCI_ERROR Failed
Read Task Duration: 00:00:46
Average Transfer Speed: 167.86 MB/s
 
Hey everyone! Today, I ran into a bit of a tricky issue while trying to read a UFS chip and wanted to share what I learned in case it helps you out.

Here is the error I encountered:
UFS Read Error – UFS_0002.00 0xEC


Error UFS_0002.00 0xEC
SCSI_READ_10 STALL_CONDITION
LBA: 0x001EB000

At first glance, it is easy to assume the problem is with your hardware, box, adapter, or connection. However, that is not always the case!

If Secure Write Protect is active on the UFS, the chip will often read normally up to a certain point and then suddenly stop once it hits a protected area. That is why the read process halts with a STALL_CONDITION at a specific LBA.

Keep in mind that you won't be able to get a 100% full UFS read until you remove that protection condition. So, before you spend time troubleshooting your programmer or adapters, be sure to check the UFS protection status first!

I hope sharing this saves some fellow technicians a bit of headache during your UFS read operations.

#UFS #UFSRead #F64 #UFSRepair #MobileRepair
 
Back
Top